Skip to content
Flake Finish

Our home base

Garage floor coating in Erie, Colorado

We're based in Erie, so this is home turf. From the older homes near Briggs Street to the newer builds in Erie Highlands and Colliers Hill, we know how this town's slabs were poured and what they need. Most Erie quotes happen the same week you ask, because we're already here.

Garages in Erie

What Erie slabs need, and what we do about it

Erie straddles the Weld and Boulder county line, and the garages split the same way. Old Town lots along Briggs and Wells have century-old houses with detached garages and slabs that have been patched, painted and parked on for generations. Everything east and south of there, from Vista Ridge to Erie Highlands and Colliers Hill, was poured in the last fifteen years. Those newer slabs look clean, but almost all of them carry a builder-applied cure-and-seal that has to be ground off before any coating will bond.

The soil under Erie is expansive clay, the same bentonite-heavy ground that keeps foundation contractors busy across the Front Range. On a garage slab that shows up as hairline cracks radiating from the corners and control joints that have opened up a little more each winter. We chase every crack, fill it with flexible polyurea filler and grind it flush before the base coat goes down, so the crack is bridged instead of telegraphing through the finish.

Because Erie is home, there is no travel charge and no waiting for us to be in the area. The owner can usually stop by for a quote the same week you ask, and if a snow day pushes your install, we can reschedule within days rather than weeks.

Searching for epoxy garage floors in Erie? We install polyaspartic instead. It is UV-stable, cures in cold weather, and does not soften under hot tires, which is why we don't install epoxy in Colorado garages. See the side-by-side comparison.

The process

Five steps on every Erie floor

Grind, test and repair, base coat, full flake, polyaspartic topcoat. Installed by the owner, usually in one day.

  1. Grind

    Diamond grinding opens the concrete so the coating can bite. No acid etch, ever.

  2. Test & repair

    Moisture test on every slab. Cracks routed and filled with flexible polyurea.

  3. Base coat

    Pigmented polyurea base coat, rolled and back-rolled for full coverage.

  4. Full flake

    Vinyl flake broadcast to refusal, so the floor is 100% covered, not sprinkled.

  5. Topcoat

    Clear polyaspartic topcoat. UV stable, hot-tire proof, and cures in cold weather.

Full process and what's included

Pricing in Erie

Typical ranges, installed

Same pricing everywhere in our primary service area. No travel charge for Erie. What moves a floor within the range.

1-car garage

≈ 200–300 sq ft

$1,800–2,600

Typical range · installed

Get my quote
Most common

2-car garage

≈ 400–500 sq ft

$2,800–4,200

Typical range · installed

Get my quote

3-car garage

≈ 600–750 sq ft

$4,000–5,800

Typical range · installed

Get my quote

Basements, patios, shops & commercial

Any size

Quote

Priced per sq ft

Get my quote

These are typical ranges for floors in average condition. Every job is quoted in person after a moisture test and a look at the slab. Your written quote is the price — no surprises on install day.

FAQ

Questions from Erie homeowners

More answers on the full FAQ.

My house in Colliers Hill is only two years old. Is the slab ready to coat?
Usually, yes. Concrete needs at least 28 days to cure before any coating, and most Erie builders' slabs are well past that by the time you move in. What matters more is the moisture reading. We test every slab before we quote; if a young slab reads high, we either add a moisture-mitigating primer or tell you to wait a few months. We would rather delay than coat over a problem.
Do you coat detached garages in Old Town Erie?
Yes. Older detached garages usually have thinner slabs with pitting, old paint and decades of oil. They take more grinding time, which is priced into the quote. Occasionally a slab is too deteriorated to coat well, and we will tell you that at the walkthrough rather than take the job.
Is there any travel charge inside Erie?
None. We are based here, and Erie jobs are the easiest for us to schedule. Send a quote request and the owner can usually be at your driveway within the week.
Why do you grind instead of acid etching?
Acid etching only cleans the very top skin of the concrete and leaves behind a weak, powdery layer. Coatings stick to that layer, and then the layer lets go of the slab. Diamond grinding removes it entirely and opens the pores so the base coat locks into solid concrete. It's the difference between a floor that lasts 15 years and one that peels in 2.
Do you really test for moisture on every slab?
Yes, every one. Colorado slabs, especially newer pours and anything below grade, can push enough water vapor to lift a coating from underneath. A moisture test takes us a few minutes and tells us whether you need a moisture-mitigating primer. We'd rather find out before we coat than have you find out after.

Free in-person quote

Ready for a floor you never think about again?

Send a quote request for a free in-person quote. The owner comes out, tests the slab, and gives you a written price on the spot.